Ge Washer Motor Inverter Board Codes

Washers resetting the electronic controls.

Ge washer motor inverter board codes.

To reset the inverter control after the component problem is resolved unplug the washer from the wall outlet until you hear a click when the inverter control capacitor discharges about 15 seconds. Plug the washer back into the outlet and then open and close the washer lid 5 times in a 12 second period within the first 30 seconds of powerup. If the motor isn t the problem then the inverter or the control board is the problem. I tested the new board and it has the same corresponding readings.

If the washer was stopped before the cycle was complete. The original inverter did provide any ohm readings between the red and blue red and white and blue and white plug ends with my ohm meter. The motor will not spin the drum in test mode t10 t11. My kenmore washer model 796 4027 2900 stopped working and the power light would not come on.

Over volts dc bus inverter. To test this place the washer in the service mode and run one of the following test modes t10 t11 or t14 it doesn t matter which one. To enter the ge cleanspeak washer service mode press and hold the start button while rotating the washers cycle selection knob 180 degrees 8 clicks then release the start button your ge cleanspeak washer should display 00 when first entering the service mode. Check motor t10 tumble t11 spin t13 spin.

I checked breaker plug etc. A power failure or if it was put in the test mode at the factory. Unplug the washer and check the drive motor for loose wiring connections. And bought a mother board.

If the problem persists replace the inverter control board which is next to the motor and manages drive motor speed. The following applies to top load washers that are equipped with the hydrowave system check model specifications for models that have the hydrowave system generally on select models available 2011 2015 if your washer fills with water but does not agitate or spin you may need to reset your washer motor. There is a service mode on ge front loader washer models that can help test the motor inverter. If there is a pause in the washer cycle the controls will lock up.

Power down unplug washer wait 30 seconds and retry if reoccurs replace inverter. If the wiring connections are okay replace the drive motor. The pause can occur because of the following. Top load washer hydrowave motor reset.

Under volts dc bus voltage inverter.