Press and hold the wall console button until the garage door is completey closed.
Genie garage door sensors not working.
Once your garage door is secure pull down on the manual release cord which should be red and located next to the garage door motor.
Cycle the garage door through the opening and closing actions using the control on the garage wall.
If the sensors are working the garage door should immediately stop closing and return to the open position.
If both the red source and green sensor lights are on and not blinking then the door mechanism is working properly.
Knowing how a garage door sensor works allows a homeowner to be watchful for what might affect it.
Door starts down then stops before it is closed.
Check for interference from adjacent photo eye sensors of any brand.
Doityourself has a wonderful explanation.
When the device detects any person or object in the path of a closing garage door it signals the motor to stop the downward action and switch the motion into reverse to stop the obstacle being crushed.
If the problem persists check to see if the red safe t beam led indicator is blinking.
The likely culprit is an obstruction in the path of the garage door.
If an operational problem exists and the garage door opener will not close the opener can be forced to close.
There are a few common reasons a genie garage door opener will stop functioning.
If it is be sure that the lenses are mounted five to six inches from the floor on either side of the garage door opening.
When this happens your garage door will only close by holding down on the wall button or wall console until the door fully closes.
Check for and clear any obstructions in its way.
Check the mechanism s source and sensor leds.
One question that is frequently asked why isn t my genie not working.
You will find that the door will only move an inch or so in the close direction and reverse.
Press the button that closes the garage door on the garage wall or on your remote.
How a garage door sensor works.
If one or both of the lights are off check the fuses breakers and plugs for problems.
Remove any debris dust or cobwebs from the electric eye lenses on each sensor with a clean rag.